Chapter 14

Landing Gear

Note: This is just a summary of the FCOM content that regularly shows up in Type Rating exams. For an overview of the systems in this chapter, check the FCOM

GEAR WARNING LIGHT

Illuminates red when:

  • Gear is in transit
  • Gear lever position disagrees with landing gear position
  • Gear is not down and locked below 800ft RA with either thrust lever in idle

LANDING GEAR TRANSFER UNIT

The landing gear retraction normally uses hydraulic system A. The landing gear transfer unit uses hydraulic system B to aid in retraction in certain conditions:

  • Aircraft is airborne
  • Engine N°1 RPM is below a limiting value (engine 1 failed)
  • Landing gear lever is selected up
  • Either main landing gear is not up and locked

BRAKES / AUTOBRAKES

Normal brakes use hydraulic system B for operation. If system B is not available, alternate brakes use system A. If hydraulic system A & B are lost, then the brake accumulator can supply limited pressure for brake operation.

Autobrake provides automatic maximum braking in the event of an RTO or preselected braking during landing. Autobrake is only available with normal brakes. The antiskid system is available with normal and alternate brakes. Autobrake RTO will engage only above 90kt wheel speed.

ANTI SKID SYSTEM

The anti-skid system prevents locked wheels by comparing the wheel speed of the two inboard main wheels and the two outboard main wheels. When a locked condition is sensed, brake pressure to the slower wheel is released. The anti-locking system is available only above 25 kt.

The anti-skid system releases brake pressure to a wheel sensed in a skid situation. Protection against hydroplaning is available for wheels 1 & 3; it is detected when the wheel speed is 50kt below GS.