• With A/T engaged, what condition could cause the throttles to be separated (not aligned).

    • ✅ One EEC in ON, one EEC in ALTN.
    • ❌ Throttle stagger cannot occur with A/T engaged as both throttle servo motors work identically to position the throttles symmetrically.
    • ❌ Both EECs in ALTN.
    • ❌ One engine A/T suffering a system fault.
  • During an In-flight start, if a wet start is detected, when will the EEC turn off ignition and fuel to the engine?

    • ❌ 10 seconds after start lever moved to Idle.
    • ❌ 15 seconds after start lever moved to Idle.
    • ❌ As soon as the wet start is detected by the EEC.
    • ✅ No in-flight abnormal start protection.
  • When GRD is selected and the eng start switch is selected to either 1 or 2, how are the crew alerted to the start valve opening?

    • ❌ An amber START VALVE OPEN alert is displayed on the lower DU.
    • ✅ A START VALVE OPEN alert is displayed on the upper DU.
    • ❌ The only indication is the N2 gauge increasing to Max Motoring (25%).
    • ❌ The blue START VALVE light illuminates bright blue then goes dim blue once the start valve is fully open.
  • If the forward thrust lever is reduced to idle while the EEC is in the soft alternate mode, what is the result?

    • ❌ Approach idle is commanded by the EEC.
    • ❌ The EEC will remain in the soft alternate mode, the ALTN switch illuminates and the ON indication remains visible.
    • ❌ The EEC enters the hard alternate mode, the ALTN switch remains illuminated and the ON indication is blanked.
    • ✅ The EEC enters the hard alternate mode, the ALTN switch remains illuminated and the ON indication remains visible.
  • With the APU running, how can it be stopped immediately?

    • ❌ Move the APU START switch to OFF.
    • ❌ Rotate APU FIRE switch
    • ✅ Switch the battery off.
    • ❌ All of the above.
  • On a ground start, if a Wet start is detected, when will the EEC turn off ignition and shut off fuel to the engine.

    • ❌ 10 seconds after start lever moved to idle
    • ❌ The EEC does not turn off ignition and fuel - this is a crew responsibility.
    • ✅ 15 seconds after the start lever moved to Idle
    • ❌ 15 seconds after throttle lever moved to Idle
  • Which bus powers the right igniter plug?

    • ❌ AC Transfer Bus 1
    • ✅ The AC Standby Bus
    • ❌ AC Transfer Bus 2
    • ❌ DC Bus 1
  • Which bus powers the left igniter plug?

    • ❌ The AC Standby Bus
    • ❌ DC Bus 1
    • ❌ AC Transfer Bus 2
    • ✅ AC Transfer Bus 1
  • Which indication is NOT supplied to the Secondary Engine Indications on the lower DI via the EEC?

    • ❌ Oil temperature
    • ❌ Fuel flow
    • ❌ Oil pressure
    • ✅ Oil quantity
  • In flight, with the APU as the only source of electrical power; if the electrical load exceeds the APU Generator design limit, the galley busses and the IFE busses are the first to be automatically shed.

    ❌ False

  • What condition would cause an automatic shutdown of the APU?

    • ✅ An APU high oil temperature condition occurs or The APU overspeeds or APU fuel control unit failure.
    • ❌ An APU high oil temperature condition occurs or The APU overspeeds.
    • ❌ The APU overspeeds or APU fuel control unit failure
    • ❌ The APU has no automatic shutdown protection - shutting down the APU is always Flight Crew initiated.
  • What is the indication that the thrust reverser sleeves have moved from the stowed position and have reached the deployed position?

    • ✅ The REV thrust reverser indication located on the upper display unit illuminates green.
    • ❌ The REVERSER light on the aft overhead panel illuminates.
    • ❌ The reverse thrust lever may be moved beyond the interlock position.
    • ❌ The amber REV thrust reverser indication located on the upper display unit illuminates.
  • What is the indication of an impending oil filter bypass due to contamination?

    • ❌ Illumination of the Master Caution and ENG system annunciator lights.
    • ✅ An amber OIL FILTER BYPASS alert illuminates on the upper display unit.
    • ❌ An amber OIL FILTER BYPASS alert illuminates on the upper display unit and illumination of the Master Caution and ENG system annunciator lights.
    • ❌ Illumination of the FILTER BYPASS warning light on the Fuel Panel.
  • The engine start valve closes and the START VALVE OPEN alert on the upper DU extinguishes at approximately ?

    • ❌ 20% N1
    • ❌ 25% N2
    • ❌ 50% N2
    • ✅ 56% N2
  • With the fuel pumps off, where does the APU fuel supply come from?

    • ❌ From tapping in left engine supply line.
    • ❌ Left side of the Fuel Manifold.
    • ✅ No 1 Main Tank.
    • ❌ Suction fed from Centre Tank.
  • Can reverse thrust be deployed if the aircraft has not touched down?

    • ❌ Yes, if the forward thrust levers are in the idle position and both radio altimeters sense less than 10 feet RA.
    • ❌ No, the air/ground safety sensor must be in the ground mode
    • ❌ No, the air/ground safety sensor must be in the ground mode and either radio altimeter senses zero ft RA
    • ✅ Yes, if the forward thrust levers are in the idle position and either radio altimeter senses less than 10 feet RA.
  • During an in-flight start the EGT Start Limit Redline is never displayed.

    ❌ False

  • Approach idle is selected in flight by the EECs under what normal conditions(s)?

    • ❌ Below 2,000 feet
    • ❌ Below 15,000 feet
    • ❌ Landing gear extended
    • ✅ Flaps are in landing configuration or engine anti-ice is ON
  • What effect does moving the N1 SET Outer Knob to BOTH have on A/T operation?

    • ❌ Causes the A/T system to set a reduce Max Thrust bug for both engines.
    • ❌ Causes the A/T system to disengage.
    • ❌ Causes the A/T system to set an increased Max Thrust bug for both engines.
    • ✅ Has no effect on the A/T system operation.
  • Which ENGINE START switch position will provide ignition to both igniters regardless of igniter selector switch position when the engine start lever is in IDLE?

    • ❌ GRD
    • ❌ CONT and FLT
    • ❌ CONT
    • ✅ FLT
  • When is the EGT Start Limit Redline displayed?

    • ❌ The EGT start Limit Redline is only displayed if the EGT exceeds the Start Limit.
    • ❌ Until the engine achieves self sustaining idle (approx 50%)
    • ❌ Until starter cutout speed (approx 56%)
    • ✅ Until the engine achieves stabilised idle (approx 59%)
  • When does the OIL FILTER BYPASS alert illuminate on the upper display unit?

    • ❌ Illuminates just prior to oil pump bypass opening as pressure gets near to pressure required to open the bypass.
    • ❌ Once the oil filter bypass has opened and oil is bypassing the filter.
    • ❌ If the oil filter bypass has failed in the closed position and oil pressure is beginning to increase.
    • ✅ Illuminates prior to oil bypassing the scavenge filter.
  • After starting the engine and it achieving Stabilised Idle (59% N2), a low oil pressure condition would be identified by the amber LOW OIL PRESSURE annunciation on the upper DU, and the Lower DU displaying OIL PRESS Pointer in the Amber band.

    ❌ False

  • Where in the engine oil system is the oil filter located?

    • ❌ In the oil tank
    • ✅ In the engine oil return line before reaching the oil tank
    • ❌ In the engine bearings supply line
    • ❌ In the engine oil supply after leaving the oil tank
  • At what point during a normal start is the EEC supplied with electrical power?

    • ❌ When the engines accelerates to a speed greater than 15% N2
    • ✅ When the engine start switch is positioned to GRD
    • ❌ When the battery switch is placed ON
    • ❌ When the engines accelerates to a speed greater than 25% N2 or max motoring
  • The APU can operate and supply bleed air only, up to the aircraft operating ceiling of 41, 000 feet.

    ❌ False

  • How is fuel heated prior to reaching the engine?

    • ❌ The IDG oil cooler
    • ❌ An electrical fuel heater
    • ❌ The main engine oil cooler.
    • ✅ The main engine oil cooler and the IDG oil cooler
  • The Master Caution lights and ENG system annunciator lights will illuminate if the EEC automatically enters the soft alternate mode.

    ✅ True

  • What condition causes the A/T LIM indication to illuminate WHITE on the upper centre display panel?

    • ✅ The FMC is not providing the A/T system with N1 limit values
    • ❌ The Forward Thrust Levers have been advanced to the fully forward position by the A/T system.
    • ❌ The Forward Thrust Levers have been manually advanced to the fully forward position.
    • ❌ The A/T system is no longer sending an EGT limit values to the FMC.
  • How is the engine fuel heated prior to entering the engine?

    • ❌ Heated by passing through engine oil heat exchanger only.
    • ❌ Heated only by Kinetic energy imparted due to pressure increase passing through the 1st and 2nd stage engine fuel pumps.
    • ❌ Engine fuel is not heated until it is burnt in the engine combustion chamber.
    • ✅ Heated by passing through IDG oil heat exchanger and engine oil heat exchanger.
  • APU cooling air enters along with APU engine air through the APU intake located on the right rear fuselage.

    ❌ False

  • Raising an engine start lever to the IDLE position opens which fuel valve(s)?

    • ✅ The related spar fuel shutoff valve and engine-mounted fuel shutoff valve.
    • ❌ The related engine-mounted fuel shutoff valve and engine bypass valve.
    • ❌ The related spar fuel shutoff valve.
    • ❌ The related engine-mounted fuel shutoff valve.
  • The REVERSER light located on the aft overhead panel illuminated during a normal reverse sequence indicates ?

    • ❌ The isolation valve has failed to open and the thrust reverser control valve has not moved to the deploy position.
    • ❌ A normal indication until the reverser sleeves are stowed at the completion of the reverse sequence.
    • ❌ One or more faults in the system if the light illuminates at the start of the sequence.
    • ✅ A normal indication if the light extinguishes 10 seconds after the thrust reverser is commanded to stow.
  • At what rotational speed is the Start Lever moved to the IDLE position?

    • ✅ Max Motoring - 25% N2.
    • ❌ Starter cutout speed - 56% N1.
    • ❌ Max motoring - 56% N1.
    • ❌ Starter cutout speed - 56% N2.
  • The B737-800 has no In-Flight Abnormal Start Protection.

    ✅ True

  • What does a Red Box around an N1 RPM Digital Readout mean - when the aircraft is on the ground and the engine has been shut down?

    • ❌ The N1 RPM display has suffered a malfunction in flight.
    • ❌ The N1 Limit Bug has been set manually.
    • ✅ An inflight exceedance has occurred.
    • ❌ This situation cannot occur - the Red Box only occurs in flight to indicate an operating limit is currently being exceeded.
  • The APU requires an AC power supply for starting.

    ❌ False

  • How is the EEC affected by the failure of one DEU (Display Electronic Unit) ?

    • ❌ Failure of a single DEU has no effect on the EECs.
    • ❌ Both EECs are rendered inoperative and the EEC ON indication extinguishes.
    • ✅ Both EECs revert to soft alternate mode and the ALTN switch illuminates.
    • ❌ The EEC for the related side reverts to soft alternate mode and the ALTN switch illuminates.
  • The APU engine air inlet door is located at the rear of the fuselage just below and forward of the left horizontal stabiliser.

    ❌ False

  • In flight, if a fault prevents the EEC receiving flap or anti-ice signals; at what altitude would the Approach Idle schedule begin?

    • ✅ Below 19,000 MSL.
    • ❌ Approach idle must be selected by the crew in these circumstances.
    • ❌ Below 20,000 feet.
    • ❌ Below 15,000 feet RA