• If a microphone is in the emission position for more than ___________ , an interrupted tone sounds for 5 seconds, and the emission is turned off.

    • ❌ 45 seconds
    • ❌ 90 seconds
    • ❌ 120 seconds
    • ✅ 30 or 60 seconds depending on configuration
  • Which radio communication equipment is still working after the completion of the emergency evacuation checklist?

    • ❌ VHF1 and 2, RMP 1 and 2, CAPT ACP, F/O ACP
    • ✅ VHF1, RMP1, CAPT ACP, F/O ACP
    • ❌ VHF1, RMP1, CAPT ACP only
    • ❌ VHF1, RMP1, CAPT ACP, F/O ACP, third ACP
  • The cockpit voice recorder records announcements transmitted over the passenger address system, if _______ is selected on the third audio control panel.

    • ❌ VHF 3 reception
    • ❌ INT reception
    • ❌ CAB reception
    • ✅ PA reception
  • When STBY NAV has been selected by the use of NAV key:

    • ❌ VHF function is lost on this ramp.
    • ❌ VHF is still available but only the last frequency selected can be used.
    • ✅ NAV key has no effect on radio com frequency selection.
    • ❌ ---
  • Which statement about the use of the HF/VHF radio is correct?

    • ❌ Check HF transmission and reception during cockpit preparation if required for the flight
    • ❌ Do not transmit on HF during refueling
    • ❌ Check VHF transmission and reception during cockpit preparation
    • ✅ All statements are correct
  • Upon receiving a call by the SELCAL system:

    • ✅ The system advises the flight crew aurally and visually. (The aural warning is inhibited during takeoff and landing)
    • ❌ The system advises the flight crew aurally only
    • ❌ The system advises the flight crew visually only
    • ❌ Nothing happens, the system is deactivated on our aircraft
  • Which statement about the cockpit voice recorder is correct?

    • ❌ Only the last 1 hour recording is retained
    • ❌ Only the last 30 minutes recording is retained
    • ✅ Only the last 2 hour recordings are retained
    • ❌ Only the last 3 hour recordings are retained
  • What is the procedure with a frozen RMP?

    • ❌ Reset RMP according QRH 80.18 (Pull the CB of affected RMP for 5s and then push it back in)
    • ❌ There is no reset procedure
    • ✅ Reset RMP according QRH 80.18 (switch OFF the affected RMP for 5s, then switch it back on)
    • ❌ Call the maintenance
  • How do you erase the CVR?

    • ❌ Press the CVR ERASE pb three times shortly when the aircraft is on the ground with the parking brake on
    • ✅ Press the CVR ERASE pb for 2 seconds when the aircraft is on the ground with the parking brake on
    • ❌ Press the CVR ERASE pb and CVR TEST pb for 2 seconds simultaneously
    • ❌ Press the CVR ERASE pb and CVR TEST pb for 2 seconds simultaneously with the parking brake on
  • Which statement about the communication system is true?

    • ❌ Four identical VHF communication systems are installed
    • ❌ All systems have one common antenna on the fuselage
    • ✅ VHF has an alarm which indicates if the microphone is stuck
    • ❌ Only VHF2 functions in EMER ELEC CONFIG
  • What would happen if your headset cable got stuck around the sidestick radio selector, thereby blocking it in the radio position for a longer period of time?

    • ❌ The system is of a fail safe type and will deactivate any transmission immediately for the remainder of the flight
    • ❌ After 30 seconds an alarm will sound only as a reminder for the crew
    • ❌ After 20 seconds an alarm will sound and the emission will be turned off
    • ✅ After 30 seconds an alarm will sound and the emission will be turned off. To reactivate the emission, you will have to release and press the PTT button again
  • What happens with the ATT light on the ACP after a call from the cabin, if it is not reset?

    • ❌ It flashes all the time
    • ❌ It stops flashing after 10 seconds
    • ✅ It stops flashing after 60 seconds
    • ❌ It comes on steady after 60 seconds together with the Master Caution light
  • Which statement is correct? The audio management system includes:

    • ❌ An audio management unit (AMU)
    • ❌ Three audio control panels (ACPs) (fourth and fifth optional)
    • ❌ Sockets at each station
    • ✅ All answers are correct
  • Can the crew switch to the third ACP if ACP 1 and 2 fail?

    • ✅ Yes
    • ❌ No
    • ❌ ---
    • ❌ ---
  • During cockpit preparation the CAPT and CAPT&PURS switch is normally in the CAPT position. What happens in this configuration if one of the cabin EVAC CMD pb is pressed?

    • ❌ Nothing
    • ❌ Only the EVAC horn sounds in cockpit and cabin
    • ✅ The EVAC light within the COMMAND pb-sw flashes red and the cockpit horn sounds for 3 seconds
    • ❌ The EVAC light flashes red and the EVAC horn sounds in the cabin and cockpit
  • Which statement is correct regarding the cockpit voice recorder?

    • ❌ It is automatically energized when the battery pb's are selected
    • ❌ It is always active after DC electrical power is applied to the aircraft
    • ❌ It is automatically energized when the parking brake is set
    • ✅ It is automatically energized on the ground with one engine running or during the first 5 minutes after the aircraft electrical network is energized
  • In case of an Emergency Call from the cabin, what are the indications in the cockpit?

    • ❌ EMER pb-sw: the ON light flashes in white
    • ❌ CALL light flashes in amber
    • ❌ Three Buzzers will sound consecutively (for approx. Three seconds each)
    • ✅ All answers are correct
  • The Cockpit Voice recorder retains the last ____ hour(s) of data.

    • ❌ 3 hours
    • ❌ 4 hours
    • ✅ 2 hours
    • ❌ 1 hour
  • The SEL indicator on both RMPs comes on amber when a transceiver, normally associated with one RMP, is tuned by another:

    • ❌ VHF1, tuned by RMP1
    • ✅ VHF1, tuned by RMP2
    • ❌ VHF2, tuned by RMP2
    • ❌ VHF3, tuned by RMP3
  • On the ground, the CVR is stopped automatically _____ after the last engine shutdown.

    • ❌ immediately
    • ❌ 1 minute
    • ❌ 3 minutes
    • ✅ 5 minutes
  • CVR: The last _____ of recording are retained.

    • ❌ 30 minutes
    • ❌ 60 minutes
    • ✅ 2 hours
    • ❌ 24 hours
  • According to normal procedures: What are the standard RMP settings?

    • ✅ VHF 1: Active ATC, VHF 2: Inflight always 121.50 MHz
    • ❌ VHF 1: Active ATC, VHF 2: Company frequency
    • ❌ VHF 1: 121.50 MHz, VHF 2: Active ATC
    • ❌ VHF 1: Active ATC, VHF 2: 123.45 MHz
  • The CVR System is energized automatically:

    • ❌ On ground during the first 5 minutes after the aircraft electrical network is energized
    • ❌ On ground with one engine running
    • ❌ In flight
    • ✅ All answers are correct
  • With the EMER EVAC COMMAND pb (on Overhead Panel) ON, what happens in the Cockpit?

    • ❌ The EVAC light in the pb-switch flashes red and the cockpit horn sounds
    • ❌ The EVAC light in the pb-switch is steady red and the cockpit horn sounds
    • ✅ The EVAC light in the pb-switch flashed red only
    • ❌ The EVAC light in the pb-switch is flashes amber and the cockpit horn sounds
  • What happens when the side stick radio selector is pressed/squeezed and the INT/RAD switch on the ACP is on INT?

    • ✅ The radio function has priority over the interphone function
    • ❌ Both the radio and the interphone functions are operative
    • ❌ The interphone function has priority over the radio function
    • ❌ Only the ground crew will hear the transmission
  • When is the cockpit buzzer combined with the interphone call from the cabin inhibited?

    • ❌ The buzzer is inhibited during take-off only
    • ❌ The buzzer is inhibited during landing only
    • ✅ The buzzer is inhibited during take-off and landing
    • ❌ The buzzer is inhibited when engines are running
  • Which statement is true about the NAV pushbutton on the Radio Management Panel (RMP)?

    • ✅ It enables the pilots to select navigation receivers and courses through the RMP
    • ❌ It affects the selection of radio communication and their frequencies
    • ❌ When pressed repeatedly, it enables the selection of the different radio navigation options
    • ❌ Pressing this key will move the active VOR frequency to the standby window and the standby frequency to the active window
  • The range of the VHF system is:

    • ❌ From 2.8 to 24 MHz
    • ❌ From 24.0 to 136.975 MHz
    • ❌ From 118.0 to 131.95 MHz
    • ✅ From 118.0 to 136.975 MHz
  • The ELT transmits on the following frequencies:

    • ❌ 121.5 MHz
    • ❌ 243 MHz
    • ❌ 406.025 MHz
    • ✅ All answers are correct
  • What is the purpose of the AUDIO SWITCHING rotary switch?

    • ❌ It enables the crew to change audio reception from headset to loud speaker and vice-versa
    • ❌ It transfers the audio reception from the ACP 1 to the ACP 2 and vice-versa
    • ✅ The crew can switch to the third ACP if ACP1 or ACP2 fails. On CAPT 3 position, the captain uses his acoustic equipment and the third occupant's ACP
    • ❌ If ACP 1 or 2 fails, the crew can switch to the third ACP. On F/O 3 position, the copilot uses his acoustic equipment and the RMP 3
  • An EMER CALL from the flight deck will activate:

    • ❌ 3 HI LO chimes in the cabin
    • ❌ The red light flashes on all ACPs
    • ❌ The EMERGENCY CALL message appears on all AIPs
    • ✅ All answers are correct
  • During EMER ELEC CONF which COM SYS is still working?

    • ❌ VHF 1&2 RMP 1&2 ACP 1&2
    • ❌ VHF 1 RMP 1 ACP 1
    • ✅ VHF 1 RMP 1 ACP 1&2
    • ❌ The communication is lost