• The maximum speed to use the windshield wipers is:

    • ❌ 200 kts
    • ❌ 250 kts
    • ✅ 230 kts
    • ❌ ---
  • The anti-icing system provides hot air to:

    • ❌ Three outboard leading-edge slats of each wing.
    • ✅ Engine air intakes.
    • ❌ Only to the inboard leading-edge slats
    • ❌ Waste-water drain mast.
  • Window heating can be selected on manually at any time by the probe window heat pushbutton:

    ✅ True

  • The probes are heated:

    • ❌ Automatically when at least one engine is running
    • ❌ Manually, when the flight crew switches ON the PROBE/WINDOW HEAT pb
    • ❌ Automatically when the aircraft is in flight
    • ✅ All answers are correct
  • The engine nacelle is anti-iced by:

    • ✅ Independent air bleed from high pressure compressor
    • ❌ Independent air bleed from low pressure compressorr
    • ❌ Electrically independent from its associated engine generator
    • ❌ The nacelle does not have an anti-ice system
  • With reference to the PROBE/WINDOW HEAT pushbutton, which of the following statements is correct?

    • ❌ When in AUTO mode, the windows are heated only when necessary
    • ❌ The system should only be selected ON after first engine start
    • ❌ The system should only be selected ON in icing conditions and one engine running
    • ✅ In AUTO mode, the window heating comes ON automatically after the first engine start
  • Where are the Wing Anti-Ice indications on ECAM?

    • ❌ There is no indication for Wing Anti-Ice on the ECAM
    • ❌ An amber triangle appears on the ECAM BLEED page only
    • ✅ ANTI-ICE appears in white on the ECAM BLEED page and WING A. ICE appears on the ECAM MEMO DISPLAY
    • ❌ WING A. ICE ON appears on ECAM STATUS page
  • ENGINE ANTI-ICE: If air is unavailable (engine not running):

    • ✅ The engine anti-ice valve closes automatically
    • ❌ The engine anti-ice valve opens automatically
    • ❌ There is no effect on the engine anti-ice valve position
    • ❌ The engine anti-ice must be closed manually
  • Which components are electrically heated?

    • ✅ All answers are correct
    • ❌ Flight compartment window
    • ❌ Sensors, pitot probes and static ports
    • ❌ Waste water drain mast
  • When engine anti ice is used, does this have an effect on the descent?

    • ❌ No
    • ✅ Yes
    • ❌ ---
    • ❌ ---
  • The wing anti-ice shut off valves are controlled by

    • ✅ One wing anti-ice push button.
    • ❌ Two wing anti-ice push buttons.
    • ❌ Automatically
    • ❌ ---
  • If a leak is detected on one side of the WING ANTI-ICE system during normal operation:

    • ❌ The crossbleed will close automatically and the APU must be used to supply the left and right bleed ducts to ensure continuous operation of the system
    • ❌ The FADEC will automatically close the affected bleed valve and increase N2 to satisfy the increased bleed air demand on the other engine
    • ❌ Both wing anti-ice valves will close automatically
    • ✅ The affected side's wing anti-ice valve closes automatically
  • Can you use APU bleed for wing anti ice?

    • ❌ Yes, but it should only be used in severe icing conditions
    • ❌ Yes, always
    • ✅ No, APU bleed will not deliver sufficient flow and pressure for the WING ANTI-ICE system
    • ❌ Yes, but only according supplementary procedures for flight with APU bleed and WING ANTI-ICE
  • On ground, the TAT probes are not heated and pitot heating operates at a low level (the changeover to normal power in flight is automatic).

    ✅ True

  • The timer supplies a measured quantity of rain repellent to the wind shield. To repeat the cycle the pushbutton must be pressed again.

    • ✅ Yes
    • ❌ No
    • ❌ ---
    • ❌ ---
  • Ice and Rain Protection: The electric wipers are controlled by two individual rotary selectors:

    ✅ True

  • Which of the following statements is correct?

    • ❌ The cockpit windshields are anti-iced by hot air and the cockpit side windows are not anti-iced
    • ✅ The window and windshield heating comes on automatically when at least one engine is running or when the aircraft is in flight
    • ❌ The window heating system has three heating levels
    • ❌ The windshield heating operates at the same power on ground and in flight
  • The engine anti-ice system...

    • ❌ Operates only in flight and is fully automatic in case of icing conditions.
    • ❌ Can not be operated on the ground to prevent damage to the slats
    • ✅ When selected ON causes N1 limit to be reduced
    • ❌ ---
  • Failure of the L or R windshield heating triggers:

    • ❌ No visual or aural warning
    • ❌ Double Chime and MASTER CAUT.
    • ✅ Single Chime and MASTER CAUT
    • ❌ ---
  • WING ANTI-ICE: In flight, hot air from the pneumatic system heats:

    • ✅ The three outboard slats (3-4-5) of each wing
    • ❌ All the slats of each wing
    • ❌ The three inboard slats (1-2-3) of each wing
    • ❌ All the slats of each wing and leading edges of flaps if extended
  • The ON light illuminates on the wing anti-ice pushbutton:

    • ❌ When the anti-ice valves open and pneumatic PX is available
    • ✅ When the push button switch is set to on.
    • ❌ When the fault light goes out.
    • ❌ ---
  • The WING ANTI-ICE shut off valves close automatically in case of:

    • ❌ The affected side's valve in case of an engine failure
    • ✅ Loss electrical power supply or leak detection on affected side during normal operation
    • ❌ Cross bleed valve fault when wing anti-ice is used
    • ❌ All answers are correct
  • Pitot heating operates:

    • ✅ At low on ground and normal power in flight.
    • ❌ In flight only.
    • ❌ On ground above 80 kts.
    • ❌ ---
  • Thin hoarfrost is acceptable on:

    • ❌ The upper surface of the fuselage
    • ✅ The upper surface of the fuselage and up to a maximum layer of 3mm on the underside of the wing tank area
    • ❌ The upper surface of the fuselage, the underside of the wing tank area and the upper side of the wing tank area
    • ❌ The upper surface of the fuselage, the underside of the wing tank area, the upper side of the wing tank area and stabilizer
  • With reference to the PROBE/WINDOW HEAT pb, which of the following statements is true?

    • ❌ The system should only be selected ON in icing conditions.
    • ❌ When in AUTO mode, the windows are heated only when necessary.
    • ❌ The system should only be selected ON after first engine start.
    • ✅ Probes and windows are heated permanently
  • In case of loss of electrical power supply, the engine anti-ice valve:

    • ❌ Opens when the engine is stopped.
    • ✅ Opens when the engine is running.
    • ❌ Closes when the engine is running.
    • ❌ ---
  • The WING ANTI ICE PB switch controls the wing anti ice system on the left and right sides simultaneously. The ON light:

    • ❌ Lights up amber.
    • ❌ Lights up white.
    • ✅ Lights up blue.
    • ❌ ---
  • An independent air bleed from the high pressure compressor protects each engine nacelle from ice. Air is supplied through a two-position (open and closed) valve that the flight crew controls with:

    • ❌ One pushbutton.
    • ✅ Two pushbuttons
    • ❌ The valves are controlled automatically
    • ❌ ---
  • Electrical heating protects:

    • ✅ Pitot probes, Static ports, Angle-Of-Attack (AOAs) probes and Total Air Temperature (TAT) probes
    • ❌ Pitot probes and Static ports only
    • ❌ Pitot probes, Static ports and TAT probes only
    • ❌ Pitot probes and Angle-Of-Attack (AOAs) probes only
  • Probe heating starts automatically when the switch is in the AUTO position:

    • ✅ In low heat after engine start (except TAT probes) and then high heat after lift off.
    • ❌ Not heated on the ground, heats automatically at lift off.
    • ❌ Operates in high heat after engine start.
    • ❌ Operates in low heat until manually selected to high.
  • When an engine anti-ice valve is open:

    • ❌ The N2 of the associated engine decreases.
    • ✅ The N1 limit is automatically reduced and, if necessary, the idle N1 is automatically increased for both engines in order to provide the required pressure.
    • ❌ There is no change in N1 limit or N2
    • ❌ ---
  • On the ground, the TAT probes are ____ and pitot heating operates at a ____ level.

    • ❌ Heated / low
    • ❌ Not heated / high
    • ❌ Heated / high
    • ✅ Not heated / low
  • The PROBE/WINDOW HEAT pb should:

    • ❌ Not be used if there is a large amount of ice and snow covering the windshields
    • ❌ Be switched ON during cockpit preparation in cold weather operation
    • ❌ Only be used if ensured that probe covers are removed
    • ✅ All answers are correct
  • There are three independent Probe Heat Computers (PHCs) automatically control and monitor:

    • ❌ Captain probes
    • ❌ F/O probes
    • ❌ STBY Probes
    • ✅ All answers are correct
  • 3 When not used, the wipers are in the lower position.

    ✅ True

  • In the event of an electrical power supply loss ...

    • ✅ The engine anti-ice valves will open automatically, anti-icing is ensured.
    • ❌ The engine anti-ice valves will close automatically, anti-icing is lost.
    • ❌ The engine anti-ice valves will be controlled by the wing anti-ice controls.
    • ❌ ---
  • If electrical power fails, the engine anti-ice valve:

    • ❌ Closes
    • ❌ Remains it its last position
    • ✅ Opens
    • ❌ Moves automatically in the mid position
  • The window heating comes on automatically when at least one engine is running or when A/C is in flight.

    • ✅ Yes
    • ❌ No
    • ❌ ---
    • ❌ ---
  • On ground, if the wing anti-ice valves remain open for more than 35 seconds after wing anti-ice is selected ON the crew is warned by:

    • ✅ A single chime and A MASTER CAUT.
    • ❌ A single chime and a MASTER WARN.
    • ❌ ---
    • ❌ ---
  • Each front windshield has an electrical wiper which can operate at:

    • ✅ Low speed and high speed
    • ❌ Only one speed
    • ❌ Low, medium, high speed
    • ❌ Interval, high speed