In flight, if blue electric pump fails the blue system:
- ❌ Is lost.
- ✅ Can be recovered by RAT.
- ❌ Can be recovered by PTU.
- ❌ Can be recovered by PSU.
If blue system is lost, the slats operation is:
- ❌ Normal.
- ✅ Half speed.
- ❌ Lost.
- ❌ ---
With a single hydraulic system failure the flight control law is:
- ✅ Normal.
- ❌ Alternate.
- ❌ Direct
- ❌ ---
If the green system is lost, flap operation is:
- ✅ Slow
- ❌ Normal.
- ❌ Lost.
- ❌ ---
After deploying the ram air turbine (RAT), is it possible to check its position and status?
- ❌ Yes, check to see if the blue system ELEC PUMP OFF light is illuminated or the "RAT" Memo on the upper ECAM Display
- ❌ Yes, on the ECAM ELEC page and in the MEMO of the upper ECAM (RAT OUT)
- ✅ Yes, on the ECAM HYD page and in the MEMO of the upper ECAM (RAT OUT)
- ❌ No, it is not possible
Each of the ______________________ systems has a fire shutoff valve in its line upstream of its engine- driven pump.
- ❌ The blue and yellow
- ✅ The green and yellow
- ❌ The green and blue
- ❌ ---
With both engines shutdown, how is it possible to pressurize the green system?
- ❌ By the green engine pump.
- ❌ By the yellow engine pump and the PTU.
- ✅ By the yellow electric pump and the PTU.
- ❌ ---
With green and yellow hydraulic systems lost, manual pitch trim is:
- ❌ Available.
- ✅ Lost.
- ❌ ---
- ❌ ---
With green hydraulic system lost:
- ❌ The NWS is lost.
- ✅ The NWS is operative.
- ❌ The NWS operates in alternate.
- ❌ ---
In case of a system reservoir overheat, the fault light stays on:
- ❌ For 30 seconds
- ❌ Continuously
- ✅ As long as the overheat lasts
- ❌ As long as the associated pump switch is NOT switched OFF
The RAT can be extended:
- ❌ Automatically in case of loss of power to AC bus 1 and AC bus 2.
- ❌ Manually from the overhead panel.
- ✅ Manually from the overhead panel or automatically in case of loss of power to AC bus 1 and AC bus 2.
- ❌ ---
How many Spoilers are still operating during YELLOW and GREEN hydraulic failure (BLUE system remaining)?
- ✅ 1 per wing
- ❌ 2 per wing
- ❌ 3 per wing
- ❌ 4 per wing
Which elevator does the yellow system operate:
- ❌ The left and right elevator.
- ❌ The left elevator only.
- ✅ The right elevator only.
- ❌ ---
The green system operates
- ❌ The left aileron.
- ❌ The right aileron.
- ✅ The left and the right aileron
- ❌ ---
If yellow system is lost, the flap operation is:
- ❌ Normal
- ✅ Half speed.
- ❌ Lost.
- ❌ ---
Which statement about the YELLOW electrical Pump is correct?
- ❌ The YELLOW electrical pump will be used immediately after an "HYD Y ENG 2 PUMP LO PR" ECAM caution
- ❌ When the pump is switched on, the YELLOW system will only be partially pressurized (cargo doors, braking and engine 2 reverse only)
- ✅ The electric pump can also pressurize the system, which allows YELLOW hydraulics to be used on the ground when the engines are stopped
- ❌ When the pump is switched ON on ground, the PTU is inhibited automatically and only the YELLOW system will be pressurized
With the green system only remaining, the auto brake is:
- ❌ Lost.
- ✅ Available
- ❌ Alternate
- ❌ ---
The fire shut off valve closes when:
- ❌ The master switch is set to off.
- ✅ The fire PB is released out.
- ❌ Automatically if a fire is detected.
- ❌ ---
What does a FAULT light in the PTU pb switch indicate?
- ❌ GREEN or YELLOW reservoir overheat
- ❌ GREEN or YELLOW reservoir low air pressure
- ❌ GREEN or YELLOW reservoir low level
- ✅ All answers are correct
During start up, when is the BLUE hydraulic system pressurized?
- ❌ As soon as the PTU is turned on.
- ❌ As soon as the BLUE electric pump is manually turned on.
- ✅ Automatically after first engine start.
- ❌ As soon as the engine master sw is set to IGN/START
The yellow system operates:
- ❌ The spoilers 3.
- ✅ The spoilers 2 and 4.
- ❌ The spoilers 1 and 5.
- ❌ ---
The green pump pressure is low (inhibited on the ground, when the engine is stopped). The FAULT light goes out, when the crew selects OFF, except during an overheat.
✅ True
What happens when the ground crew move the cargo door manual selector either to OPEN or CLOSE position (aircraft is electrically powered)?
- ❌ The yellow electrical pump is automatically energized and pressurizes the entire yellow system
- ❌ The yellow electrical pump is automatically energized and the yellow system is partly pressurized (Cargo Doors and alternate braking only)
- ❌ The cargo door will not move until the yellow electrical pump is switched on with the pushbutton on the cockpit hydraulic panel
- ✅ The yellow electrical pump is automatically energized, the yellow system is partly pressurized (cargo doors, engine 2 reverse and alternate braking only)
How many source systems provide pressure to the YELLOW SYS?
- ❌ 2 (one electrical driven pump & PTU)
- ❌ 3 (one electrical driven pump, one mechanical driven pump & one accumulator)
- ✅ 4 (one electrical driven pump, one mechanical driven pump, one accumulator & PTU)
- ❌ 4 (one electrical driven & one mechanical driven pump & one accumulator & the RAT)
In case of a system reservoir overheat, the fault light stays on:
- ❌ For 30 seconds.
- ❌ Continuously.
- ✅ As long as the overheat is detected.
- ❌ ---
With green hydraulic system lost:
- ❌ The landing gear extension is normal.
- ❌ The landing gear retraction is normal.
- ✅ The landing gear must be extended by gravity.
- ❌ ---
You have started engine 2, but the PTU has not operated to pressurize the GREEN hydraulic system. Why not?
- ❌ The PTU has been switched OFF.
- ❌ The PTU can only pressurize the BLUE system.
- ✅ TThe PTU will not operate until the second engine has been started.
- ❌ The PTU can only pressurize the YELLOW system.
If the green system is lost, slat operation is:
- ❌ Normal
- ✅ Slow
- ❌ Lost
- ❌ ---
In case of single hydraulic system low press:
- ❌ The master warning light illuminates.
- ✅ The master caution light illuminates and the single chime sounds.
- ❌ There is no warning.
- ❌ ---
If BLUE system is lost, SLAT/FLAP operation is:
- ✅ SLAT Half Speed / FLAP Normal
- ❌ SLAT Normal / FLAP Half speed
- ❌ SLAT Lost / FLAP Half speed
- ❌ SLAT Normal / FLAP Normal
In flight the eng 1 pump fault light illuminates amber in case of:
-
A reservoir low level
-
A reservoir overheat
-
A reservoir low air press
-
A pump low press
✅ True
-
With PTU in AUTO, the PTU automatically runs:
- ❌ If the blue hydraulic system is lost.
- ✅ When differential pressure between green and yellow system is more than 500 psi.
- ❌ As soon as a differential pressure between green and yellow system is detected.
- ❌ ---
The priority valves operate in case of:
- ❌ High hydraulic pressure in the green system.
- ✅ Cuts off hydraulic power to heavy load user systems if hydraulic pressure in a system gets low.
- ❌ High hydraulic pressure in the green and yellow systems.
- ❌ ---
When will normal operation of the BLUE system hydraulic pump begin?
- ✅ As soon as one engine is running
- ❌ When the first engine MASTER switch is moved to the ON position
- ❌ Only when the RAT is deployed
- ❌ After both engines are started
What does the RAT MAN ON Pb do?
- ✅ Extends the RAT, pressurizes the BLUE hydraulic system, does not couple the Emergency Generator
- ❌ Extends the RAT, pressurizes the BLUE hydraulic system, couples the Emergency Generator to the electrical system
- ❌ Extends the RAT, to get hydraulic power the RAT MAN ON Pb must be pressed a second time
- ❌ Extends the RAT, pressurizes the YELLOW hydraulic system and starts the Emergency Generator
The blue system includes operation of:
- ❌ The flaps.
- ✅ The slats.
- ❌ The flaps and the slats.
- ❌ ---
In flight, if BLUE electric pump fails the BLUE system:
- ❌ Is lost
- ✅ Can be recovered by the RAT
- ❌ Can be recovered by the PTU
- ❌ Can be recovered by the PSU
During the second engine start the PTU is:
- ❌ Automatically running.
- ✅ Automatically tested.
- ❌ Inhibited.
- ❌ ---
Normal hydraulic power is provided by
- ❌ Engine driven pumps for all systems
- ✅ Engine driven pumps for GREEN and YELLOW, Electrical pump for blue, Electrical pump for YELLOW (ground operation only)
- ❌ Electrical pumps for BLUE and YELLOW, Engine driven pump for GREEN system
- ❌ Engine driven pumps for GREEN and BLUE systems and Electrical pump for YELLOW system
You get a G RSVR OVHT ECAM message. Why does the ECAM procedure ask you to switch the PTU off first?
- ❌ You want to prevent the hot hydraulic fluid from being transferred to the YELLOW system
- ❌ You want to depressurize the YELLOW and GREEN systems
- ❌ You want to prevent the BLUE system from pressurizing the GREEN system
- ✅ You want to stop the PTU from pressurizing the GREEN system